industrial boilers epc in europ
AMD Power were to buy 10 tons of steam and one 4 tons of steam condensing steam industrial boilers epc in europ fuel gas from the company for cell processing company production and construction. From the analysis of the demand to the boiler factory, by the company solely responsible for AMD Power fully demonstrated the company's confidence in me, the smooth progress of bilateral cooperation.
Fluidised bed industrial boilers epc in europs suspend fuels on upward blowing jets of air during the combustion process. They are categorised as either atmospheric or pressurised units. Atmospheric fluidised bed boilers are further divided into bubbling-bed and circulating-bed units; the fundamental difference between bubbling-bed and circulating-bed boilers is the fluidisation velocity (higher for circulating).
One condensing gas industrial boilers epc in europ is about 70-75 cubic meters of gas consumption, gas consumption in the gas boiler general less than 80 cubic meters. Of course, different boiler manufacturers produce equipment boiler gas consumption will be different.
The picture shows the sawing unit is a sectional view of the conduit, the pipe can be seen the situation is collapsed. Wall thickness of 0.8mm, 0.6mm as the gap between the tube (in accordance with the requirements of corrosion resistance to low temperature, at least the wall thickness should be above 0.8mm, a gap between the tube should be at least 0.6mm or more). The wall thickness between the main heat exchanger tubes and the gap just meet the basic requirements, far from good design standard, which is due to the pressing pressure, the time between the constant pressure, wall thickness, material resilience, cost, and slit width mutual check and change, so that manufacturers must be able to select a balance in all aspects of parameters point, it can not be the best in all-round standard. The diameter of dust fly ash produced after the combustion industrial boilers epc in europ usually 500 microns (0.5mm), but due to adsorption of acid such that a plurality of fly ash (fly ash for the initial fluffy, bulky, easily adsorbed acidic substance) adhesion occurs, forming large flowers fly ash particles. If the gap between the pipe is too small, it is easy to cause plugging ash.