big size gas fired boilers
Environmental protection big size fired boilers use different fuel characteristics of each boiler using environmentally friendly fuel What? Common energy-saving environmental protection boiler fuel natural gas, diesel, electricity and methanol. Natural gas is the most important environmental protection boiler, its fuel natural gas is a clean energy, combustion products discharged after treatment safety. Natural gas boiler maintenance costs of environmental protection is very low compared to the energy efficiency of is very high, such as our thermal efficiency of gas-fired Stone can reach 95%. This boiler is the government's most important eco-friendly boiler. Environmental protection boiler fuel diesel fuel use in general, because of the relatively low price of diesel, sulfur dioxide and other acidic substances produced by burning it after treatment can be safe discharge standards, supporting measures that it needs storage tanks, maintenance costs are lower thermal efficiency up to 90% or even higher. Electric heating boilers are environmentally friendly boiler, wire and cable facilities is required, it is zero pollution, low maintenance costs, but the state has requirements of energy conservation, power cuts in some places the situation may occur, especially in summer the peak period. This is also a need to place special attention. Environmental protection boiler thermal efficiency of methanol selection of energy-efficient boilers, facilities storage tank is required, but also the Government's strong support for environmental protection boiler.
Harbin Thermal Power Co., the main city of Harbin is the largest cogeneration business, the company bear the city's heating area of 24 million square meters, to provide heat supply for more than 400 agencies, enterprises and 140,000 residents. Currently, the company is actively respond to the latest environmental standards introduced in China, the group mobilized up and down, stepping up technological innovation, upgrading environmental protection facilities, the project is expected to complete upgrading coal-fired big size fired boilers at the end of this year.
Harbin Thermal Power Co., the existing five boilers for heating and power generation: where to cogeneration units No. 7,8,9, and the other two hot water boilers. No. 9350 MW units which since 2017 was completed and put into operation, has achieved ultra-low emissions standards during construction. 7, No. 8 is 300 MW units were built in 2005 and 2006, these two units of environmental transformation began in 2013. Harbin Thermal Power Co., according to the latest environmental requirements, environmental upgrading facilities. First, soot emissions transformation, the introduction of advanced electric bag filter, followed by addition of sulfur, in addition to the transformation of nitrate, new burners in addition to the low nitrogen oxides of nitrogen, a wet desulfurization technologies in addition to sulfur dioxide. After four consecutive years of continuous transformation, 7,8 units in 2017, all the transformation is completed, achieve ultra-low emissions standards. For the two 116 MW hot water boiler was built in 2013, it has long been included in the transformation plan. Earlier this year preparatory work has been completed and environmental transformation has entered the bidding process in mid-October to start construction, completed renovation project at the end of December.
This standard at age requirement big size fired boilers flue soot, sulfur dioxide and nitrogen oxides emission concentration maximum permissible emission limits, and the blackness. This standard applies to coal-fired capacity and intended use of the fuel and emissions of air pollutants manage outside gas boiler boiler, and construction project environment (65t / h) In addition to power generation boilers and pulverized coal is greater than a single output 45.5MW impact assessment, design, final acceptance and after the completion of the sewage management.
When customers need to buy oil and gas big size fired boilerss, they need to know the boiler capacity that they need. Because the boiler will consume a lot of fuel during operation, the boiler capacity will cause unnecessary losses and increase the boiler cost.