100ppm daily oil tank hot water boiler
It is understood that in order to successfully promote the transformation and development of traditional coal chemical industry, January 1, 2019, letter to the Office of Henan Province workers released a special action program (hereinafter referred to as the "Program"), to promote pollution prevention campaign of Henan Province, three-year action implementation of the scheme, to speed up the traditional coal chemical industry (ammonia, methanol) industry green transformation, to achieve high-quality development. "Program" details are as follows.
First, the key tasks
1, and strictly control new capacity. Adherence to the red line capacity, traditional coal chemical enterprises prohibit new construction, new capacity expansion projects alone, is strictly prohibited without permission around the building does not meet the requirements of the industrial layout plan of coal chemical project in principle. The province's coal chemical projects and intensive clean-up, but according to the specified time limit has been approved to start construction of the project in principle, to construction, relocation and renovation projects must be upgraded into the base or campus planning. By 2020, the chemical industry out of the fixed bed coal gasifier intermittent exit single set of devices 300,000 tons / year of synthetic ammonia production capacity.
2, increase the relocation and reconstruction efforts. Further promote the densely populated towns of dangerous chemicals production enterprises and urban built-up areas heavily polluting industrial relocation of enterprises, the implementation of an intensive investigation, the establishment of management accounting, according to "a business a policy" during mode classification advance. Priority to promoting the urban area of coal chemical industry relocation, conversion or quit, not in the urban area but not in the business park to gradually move the park, according to the specified execution be discontinued or phased out. Close to exit the business to achieve the "two off three clear" (cut industrial water, electricity, removal of raw materials, products, production equipment), in situ transformation of the company to implement the upgrading of the standard industry benchmark, off-site relocation of enterprises to According to large-scale, modern principles move into the province for involving chemical industry gathering area.
3, Green transformation. Before the end of 2019, coal chemical enterprises fully completed VOCs governance. And comprehensively promote the chemical industry equipment static and dynamic sealing points, storage, handling, waste water systems, unorganized process emissions and non-normal operating conditions and other root causes of remediation. In accordance with national requirements, the timely completion of the coal chemical industry waste discharge permit issued by the work, companies must comply with the behavior of the sewage discharge permit clear conditions, various types of environmental inspection found violations, strictly and severely investigated and dealt with as soon as possible in place.
Second, the organization and implementation
1, roles and responsibilities. Relevant provincial jurisdiction over municipal government on the development of local coal chemical industry restructuring and overall responsibility, strengthen organizational leadership, with local conditions, the development of coal chemical industry restructuring and development program implementation, implementation tasks initiatives. Coal chemical industry is the main responsibility for the implementation of the restructuring and development, to strictly implement the main responsibility for production safety and environmental protection, the implementation of the relocation of the green transformation. Provincial Industry and Information Technology Department, Development and Reform Commission, the ecological environment, the Office of Emergency Management and other provincial departments according to the division of responsibilities, strengthen guidance and improve relevant policies and measures.
2, strictly implement the policy. Comprehensive use of market mechanisms, economic instruments, legal and necessary administrative means to approach, to promote enterprise restructuring and development. Strict implementation of China's industrial policy, strictly enforce the standards of environmental protection, quality, energy consumption, safety and technology. Relocation and reconstruction of urban population centers dangerous chemicals production enterprises and urban built-up area of relocation and reconstruction project focused on heavy polluting industrial enterprises, shall be given support in terms of fiscal policy, tax incentives, financial support, land policies.
3, strengthen supervision and accountability. Strengthen supervision of new capacity alone, without approval of the establishment of Chemical Industry Park, unauthorized implementation does not meet the industrial layout planning requirements of coal chemical projects, in violation of the registration and management of hazardous chemicals and construction projects "three simultaneous" (also designed, constructed, and concurrent use of illegal activities) system, etc., must be severely accountable accountability.
Fuel steam boiler and reciprocating pump works fast boiler company Henan editor that works with you about the structure of the fuel steam boiler fuel steam boiler and reciprocating pump: its compact structure, small size, high efficiency, easy to use, environmental pollution small, medium and large cities in our country is increasingly widely been used. Small fuel gas-fired boilers are generally carried out in the factory oil (gas) volume, water, air volume of commissioning, pressure gauge, safety valve adjustment, and burners, pumps and other auxiliary equipment commissioning, in order to normal operation after the entire boiler factory. A check 1. Check pump and before the filter is normal ignition into the oil boiler, gas furnace check the gas pressure is normal, not too high or too low, the valve opens the supply of oil or gas. 2. The valve on the flue must be fully open (wind deflector or throttle), otherwise the hair wash the affected, causing risk of accidents. 3. Check the control cabinet of each knob, should be in the normal position. For example: oil, gas fuel of choice, should be placed on the fuel combustion; manual / automatic water knob should be placed in the automatic position; fire / flame position small knob, on the small fire position; on the associated combustor knob position. If left in the chamber 4. The product oil or debris should be cleaned. 5. Check the boiler ignition sequence control and fire protection means should be flexible and reliable. Blast doors on the boiler should be flexible, tight. 6. Other inspection items with the same steam boiler (details see this Chapter). All the above work can only be completed after the ignition is started. Second, the fuel gas boiler ignition start (a) auto-ignition process boiler according to claim 1. For process control "Steam Boiler Safety Technology Supervision" predetermined fuel gas boiler to be fitted reliable ignition and flame protection program control means, and for ignition program, the total ventilation time before the ignition and the principles set forth requirements. Fuel gas-fired boiler automatic ignition control procedures are procedures for the operation command center, the heart of the program controller is fully automatic operation, the process control system fully into account all the necessary interlocks to prevent operating errors and accidents caused by equipment failure, It represents good security. Core within the process control system is a controller are basically three: (1) a mechanical process controller; (2) electronic program controller; (3) real-time control microcomputer program controller. But whatever the controller uses, roughly five main steps procedure: automatic furnace purging process, the program auto-ignition, flame protection program, program safety interlock protection, the combustion load adjustment procedure. There leak gas boiler control program. Belonging to the reciprocating pump displacement pump, it is to rely on reciprocation of the piston or plunger of the pump cylinder, the pump cylinder working volume cyclically expanded and reduced to suction fluid. Reciprocating pumps generally consists of two basic components, to achieve an end pressure energy is converted into mechanical energy, and part of the liquid fed directly, or said hydraulic cylinder end portions; and the other end is a power transmission part, said power end. Henan is committed to fast boiler steam boiler manufacturing, product quality, reasonable prices and widespread industry praise, if you have any needs, please contact us!
2 ton gas steam boiler in Algeria
The wns series oil and gas boiler produced by ZG boiler is a fast-assembling boiler, which saves time and labor and is easy to operate. ZG boiler can produce this boiler with a capacity of 1-20 tons. Such wns series oil and gas boilers have steam boilers, hot water boilers, and many applications in schools, hotels, swimming pools, packaging plants, food industries and other industries. This kind of wns oil and gas boiler is easy to install, and customers with small footprint can choose the capacity and the number of boilers (install one boiler or two or more boilers) according to their needs.
SZS oil fired steam boilerin ZG company is a typical watertube steam boiler. 15 ton SZS oil fired steam watertube boiler is with double drums and horizontal structure in designs. Its mainly parts includes double drums, membrane type water cooling wall, convection tube bundle and flue gas condensation recovery device. Oil fired steam boiler adopts “D” type layout which has advantages of small occupation area, easy to transport. This steam boiler adopts membrane water wall structure and the overall boiler uses airtight inner guard plate with full closed welding structure, the chamber wall has good sealing performance. This SZS IBR oil fired boiler adopts automatic burner, using continuous electric adjustment for water supply. It has high combustion efficiency, multiple protection function, safe and reliable operation.