blast furnace gas fired boiler manufacturer in kerala
The wns oil and gas blast furnace fired boiler manufacturer in kerala fuel we designed generally uses natural gas, light oil, heavy oil, coke oven gas, biogas, and the like. As such, it is convenient when using fuel, and the fuel can be delivered by piping. This boiler uses a fully automatic low nitrogen burner and flue gas recirculation system (FGR) system to achieve ultra low nitrogen emissions.
Solid chars produced in the initial stages of combustion of biomass fuels are of very low density. Conservative selection of furnace section size is used to reduce gas velocity and keep char entrainment into the flue gases and possibly out the stack at acceptable levels. Biomass fired steam blast furnace fired boiler manufacturer in kerala has won many national patents and prizes in China.
Increase productivity blast furnace fired boiler manufacturer in kerala system must first be optimized for verification, including the entire steam system for a complete analysis, and focus on some of the energy waste places. Via check can often find opportunities to save energy, increase productivity, and environmental protection have a positive contribution of. Check includes a steam generation, distribution, use and condensate recovery. The main steam waste requiring special attention place: exhaust gas boiler: boiler efficiency emissions system the most important indicators, the loss of energy is the most important place. Combustion air: general air enters the combustion furnace of the genus room temperature, require a lot of heating energy, i.e., the most commonly used power saving mode using a high temperature exhaust gas to preheat the combustion air of boiler, boiler efficiency can be significantly improved. The fuel / air ratio: Proper oil / gas mixture can only complete combustion, if the lack of air, combustion is incomplete, not only smoky pollution, environmental protests caused nearby residents, and easy carbonized grease gun and boiler heating tubes affect performance. If excess air is formed wasted energy, reducing boiler efficiency. Via the oxygen content of the tail gas can appropriately adjust the oil / gas ratio. Oil-fired boiler exhaust gas which content 3%, i.e., the excess air of about 15%, as the standard combustion control.
Since our company uses WNS6-1.25-YQ split two condensing blast furnace fired boiler manufacturer in kerala, the boiler runs very stable, high degree of automation, greatly reducing the labor intensity of fireman our staff, because running very clean without any emissions, but also greatly improved our paper mill house and the surrounding environment, high operating efficiency boilers. Service is also very timely response to our technical consulting reply quickly and accurately. Especially for regular visits to thank! --customer feedback