safety booklet for gas boiler
Heating safety booklet for boilers should pay attention to what is running on coal gasification project, the cost of gas-fired boiler more and more people's attention, which mainly include investment costs and operational costs of the initial equipment. What is the cost? How much concrete include? The initial investment costs including financing costs of gas boiler purchase cost of the equipment purchase cost and construction cost of equipment, as well as gas networks. It should be emphasized that the cost of gas boiler ancillary equipment commonly used to adjust the pressure equipment, measuring equipment and burners, and procurement costs because of different brands vary. Construction costs are a major natural gas pipeline set of so-called gas network tariffs, it refers to co-ordinate government funds charged to gas customers. Due to the huge gas boiler gas consumption, the cost is very large, it has become a key factor in the development of gas-fired boiler users. The key gas boiler heating period operating costs is the cost of gas. The sales price of natural gas in different regions is different. But now, the cost of heating the gas is much higher than the cost of coal-fired heating heating enterprises. To sum up, gas boiler heating costs significantly higher than traditional coal-fired boilers. However, the clean fuel gas boilers, atmospheric environment conducive to the protection of the city, so in the long run, the use of gas-fired boiler heating is more economical.
The 4ton biomass steam safety booklet for boiler is specifically designed to use biomass pellets as fuel. Installed at Vietnam, a tobacco processing facility, the boiler reduces the use of fossil gas. Operating at 16 bar pressure, the boiler has a nominal capacity of 4 ton per hour of dry, saturated steam.
Fuel gas control step and the blowing process air volume of the total fuel gas steam safety booklet for boiler steam boiler is achieved by adjusting a liquid coupling scoop blower. Organization fuel gas steam boiler combustion, is to make a, air pressure, air flow of secondary air with the good. Adjusting the amount of primary air should meet it carries the fuel into the furnace ignition of volatile oxygen required, and to maintain a certain speed, and without clogging the fuel discharge pipe of the jet having a certain rigidity. Primary air volume is too large and too small, the wind speed is too high and too low, should be avoided. In addition to adjusting the secondary air of combustion of the fuel should ensure that the oxygen demand, but must maintain a certain wind speed and primary air is mixed with the master time should have a strong stirring and mixing coke penetrate "the Gray" kinetic , which requires the case may be, each layer of the secondary air flow rate, in order to achieve stable combustion and flue gas excess oxygen appropriate destination. Fuel gas steam boiler, secondary air with what is better? Primary air volume air volume of the total share is called the primary air rate. A small air fraction, pulverized coal is heated to at least the heat required for the ignition point, fire faster, but the amount of primary air to satisfy the principle of combustion of volatiles. Secondary air mixed with the primary air time to the right. If it is mixed before ignition, means an increase in the amount of primary air, so that the ignition delay; hypoxia combustion secondary air if mixed will make late after ignition; if secondary air is mixed all at one position, since the secondary air temperature well below flame temperature, the flame temperature decreases, the combustion slows down, causing the fire. Therefore, the secondary air mixed with fuel should be based on the nature of the combustion zone as required timely sent, so that the combustion of oxygen, and will not reduce the flame temperature to ensure complete combustion and ignition stability. One or two wind speed with what is better? Fuel gas steam boiler once the wind speed is high, the fuel gas stream will catch fire in places far away from the burner, the ignition point postponed; once the wind speed is too low, it will cause a blocked ducts, and ignition point is too far forward, the burner will burn , but also easy to coke near the burner.
Our company processes in multiple new energy automobile production will need to heat, the safety booklet for boiler equipment we choose is really a headache, fast Boiler solve our urgent needs. The purchase of electric water boiler system is simple, easy to operate, easy to maintain, high thermal efficiency, saving a lot of operating costs for our company. --customer feedback