chain grate biomass coal stoker steam boiler
For the 2018-2019 autumn-winter air pollution prevention and control work, Jinhua City, Zhejiang Province issued a public draft, mainly in the autumn and winter to reduce heavy pollution weather Development frequency.
Take measures to reduce coal comprehensive, non-electric focused on reducing the total coal consumption, in 2018 the city's total coal consumption reduction of 1% compared with 2015. New non-owned coal-fired units, the implementation of new large-scale coal-fired units and coal consumption of the same amount of capacity reduction or substitution, elimination of energy consumption, water consumption, environmental protection and safety is not up to 300,000 kilowatts coal-fired units. Development of industrial parks "One District One heat source" action plan, and more than 300,000 kilowatts coal-fired units were heating transformation, promote backward and shutting down small coal-fired thermoelectric integration of coal-fired boilers in the range of 15 km radius of the heat. Optimize the use of natural gas structure, in principle, to new natural gas cogeneration and gas chemical projects, to the new "coal to gas" projects, should adhere to increase coal gas reduction synchronized to gas will change, the premise of the gas supply contract signed and orderly implementation.
Coal-fired boiler (with tea furnace, operating a stove, grain storage and drying equipment, coal-fired facilities) carried out an intensive investigation to ensure that no dead ends, no blind spot. Investigation and the coal-fired boilers to register one by one.
According to the law to increase the city's efforts to phase out coal-fired boilers in accordance with regulations. Before the end of December 2018, the city basically out of 10 tons of steam per hour of coal-fired boiler, built-up areas out of 35 tons of steam per hour coal-fired boilers. Complete 1 set (Yiwu) per hour, 40 tons of steam coal-fired boilers transformation of ultra-low emissions, coal-fired plants to achieve ultra-low emission levels.
In principle, the boiler NOx emission is not higher than 50 mg / m, and comply with appropriate safety boiler specification. New installation and reconstruction of gas-fired simultaneously supporting the low NOx combustion device.
Biomass boilers to carry out a comprehensive investigation, complete control of boiler scale, distribution, fuel, furnace, pollution control facilities and pollutant emissions, and establish a list of management accounting. Yan Gesheng biomass boiler registration, strictly control the new urban area of biomass boilers. Biomass boilers should be dedicated boiler, coal and other prohibited blended with other fuels, efficient dust bags and other ancillary facilities. Actively promote the urban area of biomass boilers ultra-low emissions transformation. For existing biomass boilers, environmental inspection carried out one by one, there are multiple distributed biomass boilers, the implementation of the demolition of small and large industrial agglomeration area.
As a leading chain grate biomass coal stoker steam boiler manufacturer in China, ZG Boiler keeps manufacturing high quality industrial steam boiler for all industrial area. Among one of IBR steam boiler manufacturers, ZG Boiler researches, engineers, manufactures and sells industrial steam boilers for a wide range of commercial and industrial applications. Different division, different steam boiler. For example, because of different fuels, our main products can be IBR biomass fired steam boiler, IBR coal fired steam boiler, IBR gas fired steam boiler, IBR oil fired steam boiler, IBR CFB steam boiler, etc. Those IBR steam boilers also can be divided into single drum steam boiler and double drum steam boiler. Our honestly consumers can choose horizontal steam boiler and vertical steam boiler. Here, as a IBR steam boiler manufacturer in China, I wound like to introduce IBR steam boiler in fuel difference.
Mature technology in biomass boiler, our SZL series chain grate boiler widely available renewable energy technology that generate steam from 6 to 40 ton to any industry factories, facilities, plants, etc. What’s more, our ZG Boiler can can supply larger capacity and high pressure circulating fluided bed, power plant boiler, biomass boiler, produce steam for electricity or other requirements. A fully automated operation system, similar to those used for conveying feed and grain on farms, delivers biomass pellets from an outdoor silo to the boiler’s hopper. At a rate predetermined by user-controlled settings, a fuel-feed system then delivers the pellets to a combustion chamber. Pellets are burned using staged combustion air injection (a process that reduces NOx ). A cyclone separator knocks out particulate matter that is then removed by an on-line, automated mechanical cleaning and ashremoval system. Usually, biomass fired cfb boiler has higher thermal transferring efficiency than chain grate boiler. And both of them can burn mixed fuels like wood pellet and coal; bagasses and coal; palm shell and coal etc.
Mill chain grate biomass coal stoker steam boilers to reduce pollution which method 1, leak checking and maintenance of protection: 2 mm steam leakage will cause energy losses of more than 10 tons of coal each year do? When you do not use it, you can turn it off to save energy. For water, steam and compressed air leak survey and routine maintenance, cost very little. 2, the non-contact cooling water in repeated use: Since the non-contact cooling water temperature and the quality is very good, it can be reused for desizing, scouring, rinsing and other processes. Three best source of cooling water is regenerated: sintering machine, a pre-link and compressor systems. The plant water recovery system may be installed, pipes, valves, storage tanks, and control systems. 3, reuse of steam condensate: textile mills require large amounts of saturated water vapor in the dyeing process, wherein a portion of the condensate is converted to its high temperature and purity. Water can be pumped back to the boiler to form a new steam. For those who buy steam from suppliers, or boiler is located away from the dyeing process, the condensate can be used as water washing or desizing. 4, pre-treated wastewater reuse Procedure collected bleaching, mercerizing machine, the water can be reused in other programs, there is no direct discharge of wastewater. 5, hot wash water is recovered from the hot gas in the dyeing process, large amounts of hot water are used to wash. Heat the washing water can be collected by the system plate heat exchanger to preheat the water to be sent to the next washing. 6, pre-screened coal enterprises should introduce screening spiral coal boiler technology to selection of raw materials. It is possible to improve the media tell the good, the bad quality of proportion, to avoid loss of small volumes of coal and coal calorific value. 7, maintaining steam traps traps can help maintain effective delivery of the steam plant. The valve is removed from the steam pipe and prevent further condensation water, so as to avoid heat loss and reduce fuel consumption. 8, pipe insulation pipes, valves and flanges, valves and flanges experience hot waste of resources, reducing efficiency. Steam delivery device insulated to prevent vapor loss is an inexpensive, energy-saving method of .9, the heat recovery boiler chimney smoke at a temperature of 360 deg.] C, and sometimes directly discharged into the atmosphere, there is no heat recovery. In fact, this heat can be used to preheat boiler water, steam or create a new steam system. 10, optimization of compressed air systems consume a large amount of compressed air in many parts of textile machines Mills. These instruments are prone to leakage, particularly in a threaded joint, rubber joints, valves, automatic regulator, the inflatable device and the old gasket. In addition, the use of compressed air pressure is usually based on the maximum pressure setting; reduce this pressure is feasible and would not have any negative impact manufacturing.