thermax waste heat boiler 0 5 ton h
Boiler happen "water hammer" how to deal with
"Water hammer" is a major factor in the operational life of the boiler affect mainly causes boiler pressure line due to the influence of some external factors (e.g., the valve suddenly closed, the pump unit suddenly stop, etc.) a sudden and distinct change in water flow rate, so there is the risk of water hammer phenomenon.
Five into the thermax waste heat boiler 0 5 ton h, are: fast su type, tube type, version replaceable, replaceable barrel, condensing boilers. Condensing boiler for a new generation boiler, condensing technology its principle is not complicated, a simple generalization is the exhaust gas by the water vapor condenses into liquid water, thereby recovering heat of the exhaust gas, the exhaust gas temperature greatly reduced. Condensing boiler efficiency is the use of flue gas condensation heat recovery boiler to absorb latent heat from exhaust tail and the sensible heat released by condensation of water vapor, to achieve the purpose of improving the thermal efficiency of the boiler.
Using Ultraten wings condensation thermax waste heat boiler 0 5 ton h technology has greatly enhanced heat the heating rate; silicon alloy material design to achieve the depth of the condensing heat exchanger, high efficiency, high heat transfer speed. "APH the T7" ready to use the factory mode, the system design is simple and clear, i.e. security that is used, the best burner performance debugging the factory, the user can simply set up at the installation site, connected to gas, water, to a flue , it covers an area of greatly reduced.
V. Installation piping, valves, instruments and accessories
1, the instrument installation should be verified, be installed in the piping, valves, instrumentation drawings, energize the electric pump commissioning.
2, the safety valve should be installed after the hydrostatic test, the safety valve should be installed exhaust pipe, the exhaust pipe should be through the outdoor security. Exhaust pipe should be installed in the bottom of the drainage pipe connected to a place of safety. Valve shall be installed on the exhaust pipe and drainage pipe.
3, each of the sewage outfall should be connected to tank or other security, the pipe should be secured to prevent shifting or counter the occurrence of injuries blowdown.
4, the main pipe by the use of units other than the mating valve, the pipeline need to consider the thermal expansion, thermal insulation pipe wall should be.
5, the dial face pressure gauge should be correct, depending on the ease of reading and rinsing; draw red dial face, the boiler shown MAWP, rotating flexible plug should not be leaking, to smooth hydrophobic Table pipe insulation prohibited.
6, only for the manufacturer pipe valve instrument (within the range shown) or the like, the other parts of the users themselves straight pipe. If you have not ordered instrument valves, the factory produced only manufacturer to install non-national standard parts required.